Troubleshooting
If the router, Paul, the Trainer laptop and the Patient monitor are started as described in the "System setup" section, all components should be in the same network and automatically connect to each other.
While the connection between the individual components is being established, this process can be recognized by the "Connecting" message in the status window.
Problems with the connection will be displayed in this window and you will also be offered direct solutions.
If one of the components does not connect:
Check that the WLAN router is switched on and the power light on the back is flashing.
Check that the Trainer laptop is in the correct network: Paul network or Neo network.
Check that the Vitalmonitor is in the correct network: Paul network or Neo network.
Check that the stethoscope is switched on.
CAUTION
If the system is still not working properly, switch off all individual devices.
If Paul does not connect or cannot be switched off using the turn-off button on the user interface, switch it off completely using the provided magnet. For more information, refer to the Powering on the simulator section.
Now switch all devices back on in the following order:
Plug in the router and wait about 1 minute.
Switch on the Trainer laptop and the Patient monitor.
Click on the Laerdal icons on both devices to start the software.
Now connect Paul to the charging cable (wait until Paul breathes)
Switch on the stethoscope.